China adjustable steel wall braces Manufacturers Factory Suppliers

Tilt Panel Props

The push pull brace is set around the perimeter of the building to maximize the use of structural materials and is an efficient and economical seismic structural element.

MS Turnbuckle

Wire turnbuckle formwork is a kind of auxiliary tool used in aluminum formwork construction, the main function is to keep the wall vertical and horizontal by pulling the formwork turnbuckle on the...

Mivan Wall Tie

The wall tie mivan is a thin steel sheet. During the construction of concrete, the aluminum formwork panels on both sides can be "pulled" tightly to prevent the modular increase and mold explosion...

Push Pull Jack

The aluminum formwork push pull jack is composed of double rods, while the assembled push pull jack is composed of single rod, which is easy to adjust, simple to operate and stable.

Flat Tie Panel Steel Wall Tie

Flat Ties are used to connect 2 pieces aluminum panels in formwork system. There are 2 holes at both side end, they can be shutting by formwok pin and wedge, strong quality flat tie with good raw...

Aluminum Formwork Painted Channel Walers

Aluminum Formwork Painted Channel Walers, steel walers are use in aluminum formwork system. Double Tube of walers will be installed to ensure the support channels. Material: Q235.

Supporting Strut 2 Tubes 3 Supports

Adjustable Plumbing Brace Accessories of 2 Tubes 3 Supports. This plumbing brace can use just one tube or combine two tubes together. One tube need 2pcs of supports. If two tubes, need 3pcs of...

Aluminum Formwork Steel Supporting Strut

Turnbuckle/ Alignment Clamp with Telescopic Length is convenient to use in formwork panels supporting and in concrete formwork solution. It's use for safety support and easy to assemble and...

Adjustable Painted Push Pull Props

Adjustable Painted Push Pull Props is also called as tilt panel prop, it is safety procedures for the concrete formwork constructions. It can use by just one pipe, also it can use by one complete set.

Formwork Galvanized Plumbing Brace

Formwork Panel Galvanized Plumbing Brace is also known as tilt panel prop. One set = 2pcs of tubes + 3pcs of Supports + 4 sets of nuts. Tube Thickness 48mmx2.5mm. Material: Q235. Surface: Painted...

Steel Formwork Diagonal Brace

Steel Formwork Turnbuckle Alignment Clamp is safety procedures for the concrete formwork constructions. Tube thickness:27mm. Adjust Height: 330-620mm. Weight:1.3KG. Material: Q235. Surface:...

Hex Nut for Formwork Tie Rod System

Hex Nut for Formwork Tie Rod System, it includes Tie Rod, Tie Nut, Water Stop Nut, Steel Cone and Washer Plate. As normal it is used with the square washer plate. Thickness: 37.5mm, Diagonal size:...